Wainscoting Installation: Photos and Notes from Our Interior Work

From our interior project archive

The molding is only part of this job. To get the look of smooth panels, we first had to flatten the textured wall below the chair rail. These are our original photos and notes from the process.

We used chair rail, baseboards and picture-frame molding over the prepared wall. Here is how we laid it out and got it ready for paint.

Dining room with white picture-frame wainscoting and dark upper walls

1. Lay out the chair rail

We started by marking the approximate chair-rail height. That gave us a boundary for the wall preparation and helped us leave the wall above it alone. We checked how the rail would meet the window trim before settling on the height.

We left the rail off during the skim-coating and sanding. It was easier to work on the wall without having to protect the new molding.

2. Knock down the wall texture

The first sanding did not remove all the texture. We knocked down the high spots and prepared the surface for drywall compound. The smooth finish came from the next step.

Wall preparation for picture-frame wainscoting

3. Skim-coat and check the surface

Our notes call for three coats of drywall compound, with sanding after the second coat. We added another coat wherever the surface still needed work. The goal was for the lower wall to look like a flat panel.

We checked it with a light held at different angles. That makes ridges and low spots much easier to see, and this was the time to fix them—before primer.

Smoothing the lower wall before installing molding

4. Install the chair rail

With the wall smoothed out, we installed the chair rail using a level and stud finder. We cut the molding to fit, fastened it, and checked for any wall repairs needed around the installation.

Chair rail and wall preparation during wainscoting installation

5. Prime the skim-coated wall

We removed the sanding dust and rolled PVA drywall sealer onto the new drywall compound. That was the primer used for the skim-coated wall in this process; the woodwork needs a primer suited to its own surface. We checked the dried surface before moving on.

6. Install the baseboards

We installed the baseboards with a small gap above the floor—about 1/16 inch in our original notes. A piece of sandpaper served as a temporary spacer. That left room to slide masking paper underneath when it was time to paint.

7. Lay out the picture-frame molding

We cut a 3½-inch square block of MDF to use as a spacing guide. Holding the block below the chair rail and above the baseboard gave us consistent marks without measuring every gap from scratch.

Layout marks for picture-frame molding

The distance between those marks established the vertical pieces. We adjusted the layout where windows or outlets called for it, rather than forcing the same panel size everywhere.

Picture-frame molding arranged below the chair rail

8. Fill the joints and nail holes

Once the molding was installed, we filled the nail holes and used interior painter’s caulk where appropriate at the joints and gaps. Those little details show up once the finish goes on, so we took the time to work through them.

Detail of molding joints during preparation

Photos from our wainscoting work

Wainscoting project photo from our interior work archivePainted wainscoting and trim from our project archive

For the preparation and coating steps we use on interior woodwork, see our millwork painting process. You can also browse our interior painting gallery.

Thinking about updating your trim or wainscoting? Tell us about your project.

Posted in Do it Yourself blog.